There are two ways you can test a route from the Testing Routes page:

  • Test Now: Click to see tests stop by stop
  • Show Route: Click to scroll through a list of all stops the tests at each one

Test Now

Clicking Test Now takes you to the On Route page, which lists all of the stops on this route. 

1. Click Go to First Stop.
2. On the next On Route page, do one of the following:

  • Click Test to test a device. Enter test results as you normally would. Repeat this step until you have tested all devices at this stop.
    Note: Click here for more information about testing a device.  
  • Click Test New Device to add a new device and then test it. Add device information as you normally would, and then save. Enter test results as you normally would. Repeat this step to add another new device and enter test results.
    Note: Click here for more information about adding a device. 

3. Click Go to next stop.
4. Repeat steps 2-3 until you have finished testing devices for this route.
5. Click Go To Final Review.

6. Click OK in the popup window to continue. 

This route will now be moved to the Completed Routes section on the Testing Routes page.

Show Route

Clicking Show Route takes you to the Route page, which shows all of the stops on this route on one page. 

1. On the Route page, scroll down to the first stop at which you want to start testing.
2. Do one of the following: 

  • Click Test Device to test an existing device. Enter test results as you normally would. Repeat this step until you have tested all devices on this route.
    Note: Click here for more information about testing a device.  
  • Click Test New Device to add a new device and then test it. Add device information as you normally would, and then save. Enter test results as you normally would. Repeat this step to add another new device and enter test results.
    Note: Click here for more information about adding a device. 

3. Scroll to the next stop and repeat step 2; do this until you have finished testing the entire route.
4. Click Finish Route near the top of the page.

5. Click OK in the popup window to continue. 

This route will now be moved to the Completed Routes section on the Testing Routes page.

Did this answer your question?